Driver's Seat Position Sensor Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE: Do not turn the vehicle to the ON mode, while removing or installing the driver's seat position sensor.

1. Driver's seat - Move
1.
Move the driver's seat to gain access to the driver's seat position sensor.

2. Driver's Seat Position Sensor - Remove
1.
From under the driver's seat, disconnect the connector (A).
2.
Remove the TORX bolt (B) using a TORX T30 bit, then remove the driver's seat position sensor (C).

3. All Removed Parts - Install
1.
Install the all removed parts in the reverse order of removal.
NOTE:
During installation, install the new TORX bolt to the specified torque.
Be sure to install the harness so it is not pinched or interferes with other parts.

5. SRS Operation - Confirm
1.
Turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.