LaneWatch Camera Aiming
Special Tools Required
Image Description/Tool Number
9451200.png Lane Watch Aiming Stand Set 070AK-T2AA100
9665729.png Aiming Marker 070AK-T2AA110

NOTE:
The LaneWatch camera must be aimed after one or more of the following procedures are done:
?
LaneWatch camera removal or replacement
?
Passenger's side power mirror removal or replacement
?
Passenger's side door panel removal or replacement
?
Passenger's side door panel body repair
Park the vehicle on level ground in a wide open area to avoid any reflection from objects that could affect the alignment procedure. Make sure you have at least the following amount of space around the vehicle: 6.5 m (21.3 ft) in length, 3.5 m (11.5 ft) in width.

2. Aiming Marker - Set
NOTE:
Make sure there are no other objects except the aiming target in this area.
Check the tire pressures, and adjust them to the specified value if needed.
Put a person or an object equivalent to the driver's weight in the driver's seat.
1.
Set the aiming marker to the LaneWatch aiming stand, and adjust the height of the aiming marker.
2.
Measure these points between A and B1, C and B2, D and E, and position the aiming marker by aligning the edge of the target with point E.
NOTE:
Install an aiming target on the passenger's side of the vehicle.
When marking on the floor, use suitable tape to mark the exact locations.
Leave the tape measure on the ground.

3. LaneWatch Camera - Aim

NOTE:
To stop the aiming procedure, turn the vehicle to the OFF (LOCK) mode.
If you press the LaneWatch switch while in the aiming mode, the current aiming data will be cleared.
1.
Turn the vehicle to the ON mode.
3.
Select Functional Set-Up in the Detail information & Setting.
4.
Select LaneWatch.
5.
Select Aiming Start.
6.
Press the LaneWatch switch on the end of the turn signal switch to aim the camera.
7.
Wait until the aiming process is complete.
8.
Confirm "AIMING OK" on the display.
9.
Turn the vehicle to the OFF (LOCK) mode to exit the system diagnostic menu.