Hold the pulley with the holder handle (A) and the crankshaft pulley holder (B).
2.
Remove the bolt with a socket, 19 mm (C) and a breaker bar, then remove the crankshaft pulley.
1.
Crankshaft Pulley - Install
1.
Remove any oil and clean the crankshaft pulley (A), the crankshaft (B), the bolt (C), and the washer (D).
2.
Lubricate with new engine oil as shown.
3.
Install the crankshaft pulley.
When a new crankshaft or a new pulley bolt is installed
4.
Hold the pulley with the holder handle (A) and crankshaft pulley holder (B), torque the bolt to 180 N·m (18.3 kgf·m, 133 lbf·ft) with a torque wrench and a socket (C), then remove the bolt.
5.
Torque the bolt to 39 N·m (4.0 kgf·m, 29 lbf·ft) with a torque wrench and a socket.
NOTE: Do not use an impact wrench.
6.
Tighten the bolt an additional 94 °.
When the crankshaft or the pulley bolt is reused
7.
Hold the pulley with the holder handle (A) and crankshaft pulley holder (B), then torque the bolt to 37 N·m (3.8 kgf·m, 27 lbf·ft) with a torque wrench and a socket (C).
