Cylinder Head Inspection for Warpage
3. Cylinder Head Warpage - Inspect


1.
Check the cylinder head for warpage. Measure along the edges, and three ways across the center:

If warpage is less than 0.08 mm (0.0031 in) cylinder head resurfacing is not required.
Maximum resurface is limited to the cylinder head height standard as shown.

Warpage
Standard (New):
0.08 mm (0.003 in) max.

Cylinder Head Height
Standard (New):
133.9?134.1mm (5.272?5.280 in)

4. All Removed Parts - Install

1.
Install the parts in the reverse order of removal.