Remove all of the old liquid gasket from the oil/air separator mating surfaces, the bolts, and the bolt holes.
2.
Clean and dry the oil/air separator mating surfaces, the bolts, and the bolt holes.
3.
Apply liquid gasket (P/N 08717-0004, 08718-0003, or 08718-0009) to the engine block mating surface of the oil/air separator and to the inner threads of the bolt holes. Install the component within 5 minutes of applying the liquid gasket.
NOTE:
Apply liquid gasket about 2.5 mm (0.098 in) diameter bead along the broken line (A).
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
4.
Loosely install the oil/air separator (A).
NOTE:
Wait at least 30 minutes before filling the engine with oil.
Do not run the engine for at least 3 hours after installing the oil/air separator.
5.
Tighten the mounting bolts in the numbered sequence shown.
