Disconnect the filler neck tube (D) from the fuel fill pipe. When you disconnect the tube, slide back the clamp, then twist the tube as you pull to avoid damaging it.
6.
Fuel Tank Protector A - Remove
7.
Fuel Tank - Remove
1.
Remove the mounting bolt and nuts, then move fuel tank protector B.
2.
Place a transmission jack under the fuel tank (A).
3.
Remove the front floor lower frame mounting bolts (C).
4.
Lower the fuel tank carefully.
5.
Remove the straps (A) and fuel tank (B).
6.
Remove the filler neck tube (C). When you disconnect the tube, slide back the clamp, then twist the tube as you pull to avoid damaging it.
8.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE: Before install the access panel (A), do the fuel leak check. Turn the vehicle to the ON mode, but do not start the engine. After the fuel pump runs for about 2 seconds, the fuel line will be pressurized. Repeat this two or three times, then check for fuel leakage.