Slide the side sill panel (A) forward, and remove it.
NOTE: The side clips (B, C, D) will stay in the body.
3.
Remove the side clip (B) from the body.
4.
Remove the side clips (C) from the body by turning them 45 °.
5.
Pull out the edge of the side clip (D) and cut the double-sided adhesive tapes with a utility knife, then remove the clip.
1.
Side Sill Panel - Install
1.
Carefully remove the remaining double-sided adhesive tapes from the side sill, then clean the side sill surface with a shop towel dampened with isopropyl alcohol.
2.
Install the side clips (A, B) and new side clip (C) on the side sill panel (D).
3.
Hold the panel up, and fit all the side clips into the holes in the body. Push on the panel until the clips snap into place.
