RDM Switch Removal, Installation, and Test
2. RDM Switch - Remove
NOTE: The mounting position of the RDM switch is different depending on the model.


3. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

1. RDM Switch - Test
RDM Switch Internal Resistance Check:
1.
Measure the resistance between CMBS OFF switch/RDM switch 12P connector (male terminals) terminals No. 11 and No. 8 according to the table.
If there is no resistance in one or more positions, replace the RDM switch.
Position
Resistance at normal ambient temperature
Released
12.1?14.8 k?
Pressed and held
3.1?3.8 k?
RDM Switch Indicator Drive Circuit Check:
1.
Check the LED for illumination by applying power and ground to the terminals according to the table.
NOTE: Important operating characteristic; diode bias cause a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
If the results are not as specified, replace the RDM switch.
RDM Switch Illumination Circuit Check:
1.
Check the LED for illumination by applying power and ground to the terminals according to the table.
NOTE: Important operating characteristic; diode bias cause a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
If the results are not as specified, replace the RDM switch.