Front Bumper Lip Spoiler Removal and Installation

NOTE:

Where icon is shown, click for further information.

	Detailed information, notes, and precautions
	Torque: N·m (kgf·m, lbf·ft)
*1	Double-sided adhesive tape

1.	Front Bumper Lip Spoiler - Remove

NOTE: Pull out the upper edge of the lip spoiler from the bumper face, and cut the double-sided adhesive tapes with a utility knife.

Note for installation

NOTE: If you are reusing the original lip spoiler (A), apply adhesive primer to the areas where the new double-sided adhesive tapes (B) will be applied, and then attach the new double-sided adhesive tapes to the lip spoiler as shown.

Adhesive tape requirements
Thickness	1.2 mm (0.047 in)
Width	10 mm (0.39 in)
Length	350 mm (13.78 in)

NOTE:

Scrape off the remaining double-sided adhesive tape from the bumper face, then clean the surface with a sponge dampened in isopropyl alcohol. After cleaning, keep oil, grease, and water from getting on the surface.

Fold the edge of each adhesive backing from the double-sided adhesive tapes.

2.	All Removed Parts - Install

Install the parts in the reverse order of removal.