Select/Reset/Information Switch Removal, Installation, and Test

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.


1

7475_3.0_enu_15185982_3.0

*1
Select/Reset/Information Switch Light: LED

2. Select/Reset/Information Switch - Remove


3. All Removed Parts - Install

1.
Install the parts in the reverse order of removal.


SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1. Select/Reset/Information Switch - Test



1.
Measure the resistance between terminals No. 3 and No. 5 in each switch position according to the table.

NOTE:
When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).

Position
Resistance
NEXT (i)
About 33 ?
SEL/RESET
About 1,043 ?
PREVIOUS ()
About 363 ?

2.
If the resistance is not as specified, replace the select/reset/information switch (A).