DTC Troubleshooting: P0111, P011B
DTC P0111: IAT Sensor Circuit Range/Performance Problem
DTC P011B: IAT Sensor Circuit Range/Performance Problem
NOTE: Before you troubleshoot, review the general troubleshooting information.

DTC Description
Confirmed DTC
Pending DTC
Freeze Frame
P0111 IAT Sensor Circuit Range/Performance Problem
     
P011B IAT Sensor Circuit Range/Performance Problem
     

1.
Connector visual check:

Connector visual check
?1.
Check for poor connections or loose terminals at these locations:
MAF sensor/IAT sensor 1
ECT sensor 1
ECT sensor 2

Are the connections and terminals OK?

     
YES
     
     
     
Go to step 2.
     
NO
     
     
     
Repair the connections or terminals.?
2.
IAT sensor performance check (low temperature):

IAT sensor performance check (low temperature)
?1.
Disconnect the following connector.
MAF sensor/IAT sensor 1 5P connector

?2.
Remove MAF sensor/IAT sensor 1.

?3.
Allow MAF sensor/IAT sensor 1 to cool to the ambient temperature.

?4.
Note the ambient temperature.

?5.
Connect MAF sensor/IAT sensor 1 to its 5P connector, but do not install it.

?6.
Turn the vehicle to the ON mode.

?7.
Quickly note the value of the IAT SENSOR in the DATA LIST with the HDS.
Signal
Current conditions
Values
Unit
IAT SENSOR (1)
    

?8.
Compare the value of the IAT SENSOR (1) to the ambient temperature.

Does the value of the IAT SENSOR (1) differ 5.4 °F (3 °C) or more from the ambient temperature?

     
YES
     
     
     
     
NO
     
     
     
Go to step 3.
3.
IAT sensor performance check (high temperature):

IAT sensor performance check (high temperature)
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Disconnect the following connector.

?3.
Using a heat gun, blow hot air on MAF sensor/IAT sensor 1 for a few seconds. Do not apply the heat longer than a few seconds or you will damage the sensor.

?4.
Connect MAF sensor/IAT sensor 1 to its 5P connector, but do not install it.

?5.
Check the IAT SENSOR (1) in the DATA LIST with the HDS.
Signal
Current conditions
Values
Unit
IAT SENSOR (1)
    

Does the IAT SENSOR (1) change 76 °F (42 °C) or more?

     
YES
     
     
     
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at MAF sensor/IAT sensor 1 and the PCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.?
     
NO