DTC Troubleshooting: P0339
DTC P0339: CKP Sensor Circuit Intermittent Interruption
NOTE:
Before you troubleshoot, review the general troubleshooting information.
If A/T system DTCs are stored at the same time as DTC P0339, troubleshoot A/T system DTCs first, then recheck for DTC P0339.

DTC Description
Confirmed DTC
Pending DTC
Freeze Frame
P0339 CKP Sensor Circuit Intermittent Interruption
      

1.
Problem verification (idling):

Problem verification (idling)
?1.
Turn the vehicle to the ON mode.

?2.
Clear the DTC with the HDS.


?3.
Start the engine, and let it idle for 10 seconds.

?4.
Monitor the OBD STATUS for DTC P0339 in the DTCs MENU with the HDS.
DTC Description
OBD STATUS
P0339 CKP Sensor Circuit Intermittent Interruption
 

Does the HDS indicate FAILED?

     
YES
     
     
     
The failure is duplicated. Go to step 3.
     
NO
     
     
     
If the HDS indicates PASSED, go to step 2. If the HDS indicates NOT COMPLETED, keep idling until a result comes on.
2.
Problem verification (test-drive):

Problem verification (test-drive)
?1.
Test-drive the vehicle for several minutes in the range of these recorded freeze data parameters:
ENGINE SPEED
VEHICLE SPEED

?2.
Monitor the OBD STATUS for DTC P0339 in the DTCs MENU with the HDS.
DTC Description
OBD STATUS
P0339 CKP Sensor Circuit Intermittent Interruption
 

Does the HDS indicate FAILED?

     
YES
     
     
     
The failure is duplicated. Go to step 3.
     
NO
     
     
     
If the HDS indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the CKP sensor and the PCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot. If the HDS indicates NOT COMPLETED, retest and check the OBD STATUS again.?
3.
CKP sensor circuit connectors and terminals condition check:

CKP sensor circuit connectors and terminals condition check
?1.
Check for poor connections or loose terminals at these locations:
CKP sensor
PCM
Engine ground
Body ground

Are the connections and terminals OK?

     
YES
     
     
     
Go to step 4.
     
NO
     
     
     
Repair the connections or terminals.?
4.
CKP pulse plate visual check:

CKP pulse plate visual check
?1.
Remove the CKP sensor, and check for damage to the CKP pulse plate.

Is the pulse plate damaged?

     
YES
     
     
     
     
NO