Audio System Symptom Troubleshooting - Volume does not increase with speed
ElectronicCircuitSchematics-button
Volume does not increase with speed
NOTE:
Check the vehicle 12 volt battery condition first
.
If possible, have the customer demonstrate their concern and compare it against a known-good vehicle.
Check for B-CAN DTCs and resolve them before troubleshooting.
Check the connectors for poor connections or loose terminals.
1.
Problem verification:
Problem verification
?1.
Test-drive the vehicle at freeway speeds, and monitor if the volume increases.
Does the volume increase?
YES
Intermittent failure, the system is OK at this time.?
NO
The failure is duplicated, go to step 2.
2.
Determine possible failure area (audio setting, others):
Determine possible failure area (audio setting, others)
?1.
Verify the SVC mode setting in the audio unit sound set-up.
Is the SVC set to off?
YES
Change the setting to SVC MID, and recheck.?
NO
Go to step 3.
3.
Determine possible failure area (audio unit, others):
Determine possible failure area (audio unit, others)
?1.
Go into the System Diagnostic Mode, and use the Vehicle Information diagnosis to check the VSPNE indication
.
?2.
Test-drive the vehicle with the help of an assistant, and then watch the vehicle speed in the audio display.
Is the vehicle speed indicated?
YES
Replace the audio unit
.?
NO
Go to step 4.
4.
Open wire check (B-CAN_H line, B-CAN_L line):
Open wire check (B-CAN_H line, B-CAN_L line)
?1.
Turn the vehicle to the OFF (LOCK) mode.
?2.
Disconnect the following connectors.
Gauge control module 32P connector
Audio unit connector C (24P)
?3.
Check for continuity between test points 1 and 2.
Test condition
Vehicle OFF (LOCK) mode
Gauge control module 32P connector: disconnected
Audio unit connector C (24P): disconnected
Test point 1
Gauge control module 32P connector No. 23
Test point 2
Audio unit connector C (24P) No. 24
Test point 1
Gauge control module 32P connector No. 24
Test point 2
Audio unit connector C (24P) No. 12
Is there continuity?
YES
Replace the audio unit
.?
NO
Repair an open in the wire(s) between the audio unit and the gauge control module.?
Troubleshooting Start