Audio System Symptom Troubleshooting - Volume does not increase with speed
Volume does not increase with speed
NOTE:
If possible, have the customer demonstrate their concern and compare it against a known-good vehicle.
Check for B-CAN DTCs and resolve them before troubleshooting.
Check the connectors for poor connections or loose terminals.
1.
Problem verification:

Problem verification
?1.
Test-drive the vehicle at freeway speeds, and monitor if the volume increases.

Does the volume increase?

     
YES
     
     
     
Intermittent failure, the system is OK at this time.?
     
NO
     
     
     
The failure is duplicated, go to step 2.
2.
Determine possible failure area (audio setting, others):

Determine possible failure area (audio setting, others)
?1.
Verify the SVC mode setting in the audio-navigation unit sound set-up.

Is the SVC set to off?

     
YES
     
     
     
Change the setting to SVC MID, and recheck.?
     
NO
     
     
     
Go to step 3.
3.
Determine possible failure area (audio-navigation unit, others):

Determine possible failure area (audio-navigation unit, others)
?1.

?2.
Test-drive the vehicle with the help of an assistant, and then watch the vehicle speed in the audio display.

Is the vehicle speed indicated?

     
YES
     
     
     
     
NO
     
     
     
Go to step 4.
4.
Open wire check (B-CAN_H line, B-CAN_L line):

Open wire check (B-CAN_H line, B-CAN_L line)
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Disconnect the following connectors.
Gauge control module 32P connector
Audio-navigation unit connector A (24P)

?3.
Check for continuity between test points 1 and 2.
Test condition
Vehicle OFF (LOCK) mode
 
Gauge control module 32P connector: disconnected
 
Audio-navigation unit connector A (24P): disconnected
Test point 1
Test point 2


Is there continuity?

     
YES
     
     
     
     
NO
     
     
     
Repair an open in the wire(s).?