Steering Lock Removal and Installation

SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before doing repairs or service.

1. Immobilizer-Keyless Control Unit - Remove (Without Keyless Access System)

Remove the immobilizer-keyless control unit.

2. Steering Column - Remove

Remove the steering column.

3. Steering Lock - Remove
1.
Center-punch both of the two shear bolts (A).
2.
Drill their heads off with a 5 mm (0.20 in) drill bit. Be careful not to damage the steering lock when removing the shear bolts.
NOTE: The shear bolts have left-hand threads.

3.
Remove the steering lock (B).


SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before doing repairs or service.

1. Steering Lock - Install
1.
Install the steering lock (A).
2.
Loosely tighten the new shear bolts (B).
3.
Tighten the shear bolts (A) until the hex heads (B) twist off.

2. Steering Column - Install

Install the steering column.

3. Immobilizer-Keyless Control Unit - Install (Without Keyless Access System)

Install the immobilizer-keyless control unit.

4. Immobilizer-Keyless Control Unit - Register (Without Keyless Access System)

After replacement, register the immobilizer-keyless control unit.

5. Keyless Access System - Rewrite (With Keyless Access System)

Rewrite all new remotes to the new immobilizer control unit-receiver, and make sure the immobilizer system works properly.