Ignition Key Switch Test
SRS components are located in this area. Review the
SRS component locations
and the
precautions and procedures
before doing repairs or service.
1.
Column Cover - Remove
Remove the column covers
.
2.
Ignition Key Switch - Test
1.
Disconnect the steering lock connector.
2.
Check for continuity between the terminals in each switch condition according to the table.
3.
If the continuity is not as specified, the ignition key switch is faulty;
replace the steering lock
(A).
4.
Connect the steering lock connector.
3.
Column Cover - Install
Install the column covers
.
