A/T Clutch Pressure Control Solenoid Valve A, B, C, and D Test
1. HDS DLC - Connect
1.
Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
2.
Press the engine start/stop button to select the ON mode.
3.
Make sure the HDS communicates with the vehicle. If it does not communicate, go to the DLC circuit troubleshooting.

2. A/T Clutch Pressure Control Solenoid Valve - HDS Function Test
1.
Select Clutch Pressure Control (Linear) Solenoid Valve A, B, C, and D individually in the Miscellaneous Test Menu with the HDS.
2.
Test A/T clutch pressure control solenoid valve A, B, C, and D individually with the HDS.
If the valves test OK, the test is complete. Disconnect the HDS.
If any of the valves do not test OK, follow the instructions on the HDS.
If any of the valves do not test OK, and the HDS does not determine the cause, go to the next step, and test A/T clutch pressure control solenoid valve A, B, C, and D.

3. Battery - Remove

Do the battery removal procedure.

4. Air Cleaner - Remove

Remove the air cleaner.

5. Battery Base - Remove

Remove the battery base.

6. A/T Clutch Pressure Control Solenoid Valve Connector - Disconnect
Disconnect the A/T clutch pressure control solenoid valve A, B, C, or D connector.


7. A/T Clutch Pressure Control Solenoid Valve - Resistance Check
Measure the resistance between terminals No. 1 and No. 2 for each A/T clutch pressure control solenoid valve A, B, C, and D.

Standard:
4.7?5.9 ?
If the resistance is out of the standard, replace the secondary valve body.
If the resistance is within the standard, go to the next step, and check each A/T clutch pressure control solenoid valve A, B, C, and D operation.

8. A/T Clutch Pressure Control Solenoid Valve - Operation Check
Connect a jumper wire from the negative battery terminal to A/T clutch pressure control solenoid valve A, B, C, and D connector terminal No. 1, and connect another jumper wire from the positive battery terminal to connector terminal No. 2 individually.
If an operating sound is heard, the A/T clutch pressure control solenoid valve is OK. Go to the next step, and install all removed parts.
If no operating sound is heard, replace the secondary valve body.

9. A/T Clutch Pressure Control Solenoid Valve Connector - Connect
Connect the A/T clutch pressure control solenoid valve A, B, C, or D connector.


10. Battery Base - Install

Install the battery base.

11. Air Cleaner - Install

Install the air cleaner.