Torque Converter Housing Final Drive Shaft Tapered Roller Bearing Outer Race Replacement
Special Tools Required
Image Description/Tool Number
310169.png Driver Handle, 15 x 135L 07749-0010000
310246.png Bearing Driver Attachment, 78 x 80 mm 07NAD-PX40100

NOTE:
The tapered roller bearing and the tapered roller bearing outer race should be replaced as a set.
Replace the tapered roller bearing with a new one whenever the tapered roller bearing outer race is replaced.
Adjust the tapered roller bearing preload after replacing the tapered roller bearing and the tapered roller bearing outer race.
Coat all parts with transmission fluid during installation.

1. Tapered Roller Bearing Outer Race - Remove
1.
Remove the tapered roller bearing outer race (A), the 80 mm thrust shim (B), and the secondary oil guide plate (C) by heating the torque converter housing to about 212 °F (100 °C) using a heat gun (D).
NOTE: Do not heat the transmission housing more than 212 °F (100 °C).

2. Tapered Roller Bearing Outer Race - Install
1.
Install the secondary oil guide plate (A) and the 80 mm thrust shim (B).
2.
Place the tapered roller bearing outer race (C).
3.
Drive the tapered roller bearing outer race securely using the 15 x 135L driver handle and the 78 x 80 mm bearing driver attachment so there is no clearance between the tapered roller bearing outer race, the 80 mm thrust shim, and the torque converter housing.