|
Audio-Navigation Unit Removal and Installation
|
|
|
Do not work in a dusty or dirty place. | |
|
|
|
Do not work with dirty hands. | |
|
|
|
Eject the disc before disconnecting the audio-navigation unit to prevent damaging the CD player load mechanism. | |
|
|
|
If you are replacing the audio-navigation unit, write down the audio presets (if possible), and enter them into the new audio-navigation unit. | |
|
|
|
After installing the audio-navigation unit, park the vehicle outside, and do the GPS initialization. | |
|
|
|
When the audio-navigation unit is replaced or disconnected, do the Map Matching. This part of the initialization matches the GPS coordinates with a road on the map screen. To do this part of the procedure, make sure that the navigation system displays a map, and drive the vehicle on a mapped road shown on the map screen. Do not enter a destination at this time. When the name of the current road you are driving on appears at the bottom of the screen, the entire procedure is complete. | |
|
|
|
|
|
When the audio-navigation unit is replaced or disconnected, do the Map Matching. This part of the initialization matches the GPS coordinates with a road on the map screen. To do this part of the procedure, make sure that the navigation system displays a map, and drive the vehicle on a mapped road shown on the map screen. Do not enter a destination at this time. When the name of the current road you are driving on appears at the bottom of the screen, the entire procedure is complete. | |
| 3. |
Audio-Navigation Unit Assembly - Remove |
| 4. |
Audio-Navigation Unit - Remove |
|
|
|
|
|
Do not touch the circuit board(s) with your bare hands. | |
|
|
|
Discharge static electricity from your body before and during the work. | |
|
|
|
Do not touch the terminal connector of the flat plate cable with your bare hands (If you have touched it, wipe it off thoroughly). | |
|
| 5. |
All Removed Parts - Install |
| 
