Automatic Lighting/Rain Sensor Removal and Installation
Without ACC

1. Automatic Lighting/Rain Sensor Cover - Remove
Remove the automatic lighting/rain sensor cover (A).


With ACC

2. Automatic Lighting/Rain Sensor - Remove

Without ACC

With ACC
1.
Release the lock (A).
2.
Slide the automatic lighting/rain sensor (B), then remove it.
3.
Disconnect the automatic lighting/rain sensor connector (C).
4.
Remove the silicon sheet (A).
NOTE:
Do not reuse the silicon sheet.
If the silicon sheet is not on the back of the rain sensor after removal, it will remain on the glass surface. Make sure to peel it off prior to installation.

1. Silicon Sheet - Replace
NOTE:
Never touch the primed surface on the automatic lighting/rain sensor with your hands.
Do not put on the silicon sheet out of the automatic lighting/rain sensor area.
Be careful not to touch the silicon sheet surfaces and make sure it is clean. Keep it away from dust.
1.
Remove the protective sheet A from the silicon sheet (C).
2.
Hold the protective sheet B, then set and put the silicon sheet on position (D) to the automatic lighting/rain sensor (E).
3.
Remove the protective sheet B.

2. Automatic Lighting/Rain Sensor - Install

Without ACC

With ACC
NOTE:
If the automatic lighting/rain sensor connector is connected after the battery terminal is connected, the automatic lighting/rain sensor is not confirmed by MICU.
If the MICU does not confirm the automatic lighting/rain sensor, the automatic wiper system does not work.
Connect the automatic lighting/rain sensor connector first, then connect the battery terminal.
1.
Connect the automatic lighting/rain sensor connector.
2.
Install the automatic lighting/rain sensor (A) to the bracket (B), and slide the automatic lighting rain sensor upward then lock the stopper (C).

With ACC

Without ACC

1. Automatic Lighting/Rain Sensor Cover - Install
Install the automatic lighting/rain sensor cover (A).