CVT Differential Carrier/Final Driven Gear Removal and Installation

NOTE: Inspect and adjust the carrier bearing preload whenever the differential carrier is removed.

2. Final Driven Gear - Remove
Remove the final driven gear (A).

NOTE: The final driven gear bolts have left-hand threads.


1. Final Driven Gear - Install

NOTE: Make sure to assemble the final drive shaft and the final driven gear correctly (Combination A or B) as shown in the chart if either one of them or both are to be replaced. Correct combinations of the shaft and gear can be identified by the presence or the absence of the groove as shown in the chart.
1.
Install the final driven gear (A) in the direction shown.
NOTE: The final driven gear bolts have left-hand threads.
2.
Tighten the bolts to the specified torque in a crisscross pattern in at least two or three steps.