DTC Troubleshooting: B1664
DTC B1664: Rear Interior LF Antenna Circuit Open
DTC Description |
DTC |
B1664 Rear Interior LF Antenna Circuit Open |
| |
|
1. |
Problem verification:
Problem verification
?1. |
Clear the DTCs with the HDS.
|
?2. |
Select the MODE MENU from the HDS, then enter the SELF CHECK.
|
?4. |
Check for DTCs with the HDS.
DTC Description |
DTC |
B1664 Rear Interior LF Antenna Circuit Open |
| |
| | |
Is DTC B1664 indicated?
|
|
|
|
|
|
|
Intermittent failure, the system is OK at this time. Check for loose or poor connections.? |
2. |
Keyless access control unit EXT R+, EXT R- line output check:
Keyless access control unit EXT R+, EXT R- line output check
?1. |
Press the engine start/stop button to select the OFF mode. |
?2. |
Disconnect the following connector.
|
?3. |
Press the engine start/stop button to select the ON mode. |
?4. |
Select KEYLESS ACCESS CONTROL from the ONE-PUSH START system select menu with the HDS, and enter FUNCTIONAL TESTS.
|
?5. |
Connect the voltmeter to test points 1 and 2.
Test point 1 |
Rear interior LF antenna 2P connector No. 1 (LT GRN) |
Test point 2 |
Rear interior LF antenna 2P connector No. 2 (WHT) | |
|
|
?6. |
Select CABIN REAR ANTENNA with the HDS. | |
Is there voltage?
3. |
Open wire check (EXT R+, EXT R- lines):
Open wire check (EXT R+, EXT R- lines)
?1. |
Press the engine start/stop button to select the OFF mode. |
?2. |
Disconnect the following connector.
|
?3. |
Check for continuity between test points 1 and 2 respectively.
Test condition |
OFF mode Keyless access control unit connector A (32P): disconnected Rear interior LF antenna 2P connector: disconnected |
Test circuit |
EXT R+ |
Test point 1 |
Keyless access control unit connector A (32P) No. 32 (GRN) |
Test point 2 |
Rear interior LF antenna 2P connector No. 2 (WHT) | |
|
Test circuit |
EXT R- |
Test point 1 |
Keyless access control unit connector A (32P) No. 16 (BRN) |
Test point 2 |
Rear interior LF antenna 2P connector No. 1 (LT GRN) | |
|
| |
Is there continuity?
|
|
|
|
|
|
|
Repair an open or high resistance in the wire.? | |