DTC Troubleshooting: U0155-00
DTC U0155-00: Lost Communication With The Gauge Control Module
NOTE: Before you troubleshoot, review the general troubleshooting information.

DTC Description
DTC
Freeze Frame
U0155-00 Lost Communication With The Gauge Control Module
    

1.
Problem verification:

Problem verification
?1.
Turn the vehicle to the ON mode.

?2.
Clear the DTC with the HDS.


?3.
Turn the vehicle to the OFF (LOCK) mode.

?4.
Turn the vehicle to the ON mode, then wait for at least 5 seconds.

?5.
Check for DTCs with the HDS.
DTC Description
DTC
Freeze Frame
U0155-00 Lost Communication With The Gauge Control Module
    

Is DTC U0155-00 indicated?

     
YES
     
     
     
The failure is duplicated. Go to step 2.
     
NO
     
     
     
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.?
2.
Open wire check (F-CAN_L, F-CAN_H lines):

Open wire check (F-CAN_L, F-CAN_H lines)
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Disconnect the following connectors.
Multipurpose camera unit 20P connector
Gauge control module connector A (32P)

?3.
Check for continuity between test points 1 and 2.
Test condition
Vehicle OFF (LOCK) mode
 
Multipurpose camera unit 20P connector: disconnected
 
Gauge control module connector A (32P): disconnected
Test point 1
Multipurpose camera unit 20P connector No. 13
Test point 2
Gauge control module connector A (32P) No. 20

Test point 1
Multipurpose camera unit 20P connector No. 2
Test point 2
Gauge control module connector A (32P) No. 19


Is there continuity?

     
YES
     
     
     
The F-CAN_L, F-CAN_H wires are OK. Go to step 3.
     
NO
     
     
     
Repair an open in the wire between the multipurpose camera unit and the gauge control module.?
3.
Gauge control module check (substitution):

Gauge control module check (substitution)
?1.
Reconnect the following connectors.
Multipurpose camera unit 20P connector

?2.
Substitute a known-good gauge control module.

?3.
Turn the vehicle to the ON mode.

?4.
Clear the DTC with the HDS.


?5.
Turn the vehicle to the OFF (LOCK) mode.

?6.
Turn the vehicle to the ON mode, then wait for at least 5 seconds.

?7.
Check for DTCs with the HDS.
DTC Description
DTC
Freeze Frame
U0155-00 Lost Communication With The Gauge Control Module
    

Is DTC U0155-00 indicated?

     
YES
     
     
     
Check for loose terminals and poor connections in the multipurpose camera unit 20P connector. If they are OK, replace the multipurpose camera unit.?
     
NO