U3000-49 Multipurpose Camera Unit Internal Electronic Failure
1.
Problem verification:
Problem verification
?1.
Turn the vehicle to the ON mode.
?2.
Clear the DTC with the HDS.
?3.
Turn the vehicle to the OFF (LOCK) mode.
?4.
Turn the vehicle to the ON mode, then wait for at least 5 seconds.
?5.
Check for DTCs with the HDS.
DTC Description
DTC
Freeze Frame
U3000-49 Multipurpose Camera Unit Internal Electronic Failure
Is DTC U3000-49 indicated?
YES
Check for loose terminals and poor connections in the multipurpose camera unit 20P connector. If they are OK, replace the multipurpose camera unit.?
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.?