Shift Lever Removal and Installation
SRS components are located in this area. Review
the SRS component locations
and
the precautions and procedures
before doing repair or service.
1
Torque: N·m (kgf·m, lbf·ft)
1.
Center Console - Remove
2.
Shift Cable (Shift Lever Side) - Remove
3.
Connector (Shift Lever) - Disconnect
4.
Shift Lever - Remove
5.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE: Be sure to
adjust the shift cable
before installing the shift cable.
6.
Shift Lever - After Install Check
1.
Turn the vehicle to the ON mode.
2.
Move the shift lever to each position, and check that the shift position indicator follows the shift lever operation.
3.
Shift the transmission to P position/mode, and check that the shift lock works properly.
4.
Push the shift lock release, and check that the shift lever releases. Also check that the shift lever locks when it is shifted back to P.
5.
Start the engine.
NOTE: Check that the engine starts in P or N position/mode, and does not start in any other positions/modes.
6.
Make sure the vehicle is turned to the OFF (LOCK) mode with the shift lever in P position/mode. If it does not,
adjust the shift cable
again.
