Key Interlock Solenoid Test
SRS components are located in this area. Review the
SRS component locations
and the
precautions and procedures
before doing repairs or service.
1.
Column Covers - Remove
2.
Key Interlock Solenoid - Test
1.
Turn the ignition switch to LOCK (0).
2.
Disconnect the connector (A).
3.
Turn the ignition switch to ACCESSORY (I).
4.
Check the solenoid operation by connecting power and ground according to the table.
NOTE: To prevent damage to the actuator, apply battery voltage only momentarily.
5.
If the key interlock solenoid does not work properly, the key interlock solenoid is faulty;
replace the steering lock
(B).
3.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
