Ignition Key Light Test

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1.	Column Covers - Remove

2.	Ignition Key Light - Test

Disconnect the connector (A).

Check the light according to the table.

NOTE:

When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.

Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).

If the result is not as specified, the ignition key light is faulty; replace the steering lock (B).

3.	All Removed Parts - Install

Install the parts in the reverse order of removal.