Driver's Airbag Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE: If replacing the driver's airbag after deployment, refer to Component Replacement/Inspection After Deployment for a complete list of other parts that must also be replaced.


NOTE: Wait at least 3 minutes before starting work.

2. Driver's Airbag - Remove
1.
Remove the bolts (A).
2.
Pull up on both locking tabs (B) to disconnect the connector (C).
NOTE: Be careful not to damage the connector.
3.
Disconnect the horn switch terminal (D).
NOTE: Release the locks pushing the tab (E) of the horn switch terminal.
4.
Remove the driver's airbag (F).
NOTE: If you are replacing a deployed driver's airbag, inspect the cable reel for heat damage. If there is any damage, replace the cable reel.

3. All Removed Parts - Install
1.
Install all of the removed parts in reverse order.
NOTE:
During installation, install the new bolts to the specified torque.
Make sure the clearance (A) between the steering wheel and horn pad is the specified value. If the clearance is out of the reference value, reinstall the driver's airbag to the center by tightening the bolts alternately and make sure the clearance.
After connecting the negative cable to the 12 volt battery, make sure the horn works properly.

4. SRS Operation - Confirm
1.
Do the 12 volt battery terminal reconnection procedure, turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.