Cable Reel Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE: Before doing this procedure, set the front wheels in the straight ahead position.


NOTE: Wait at least 3 minutes before starting work.

5. Cable Reel - Remove
1.
Disconnect the connectors (A).
2.
Remove the cable reel (B).


SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:
Before installing the steering wheel, make sure the front wheels are aligned straight ahead.
The new cable reel is locked by a yellow tab for center adjustment. When installing a new cable reel there is no need to rotate the cable. After the tab is removed, discard it after installing the cable reel.
If the driver's airbag is deployed, cable reel cannot be reused because of thermal damage.

1. Cable Reel - Install
1.
Install the cable reel (A).
2.
Connect the connectors (B).

3. Cable Reel - Align
1.
Make sure the front wheels are pointing straight ahead.
2.
Rotate the cable reel (A) clockwise until it stops.
3.
Rotate the cable reel counterclockwise until the arrow mark (B) on the cable reel points straight up.
4.
Rotate the cable reel counterclockwise two full turns. The arrow mark on the cable reel should point straight up.

6. SRS Operation - Confirm
1.
Do the 12 volt battery terminal reconnection procedure, turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.