Throttle Body Removal and Installation

Do not insert your fingers into the installed throttle body when you turn the vehicle to the ON mode, or while the vehicle is in ON mode. If you do, you will seriously injure your fingers if the throttle valve is activated.

NOTE:
enu_12713377_2.0 Where icon is shown, click for further information.
If you are replacing the throttle body, do the all procedures.
If you are removing the throttle body, do 3rd procedure (Intake Air Duct F - Remove) through 9th procedure (Engine Coolant - Refill).


1

1976_3.0_enu_14144858_3.0

enu_12713377_2.0
Detailed information, notes and precautions
enu_12714505_1.0
Torque: N·m (kgf·m, lbf·ft)
enu_12714524_1.0
Replace

2. TP POSITION CHECK - Select
1.
Select the INSPECTION MENU on the HDS.
2.
Do the TP POSITION CHECK in the ETCS TEST.
3.
Turn the vehicle to the OFF (LOCK) mode.
4.
Turn the vehicle to the ON mode, and wait 2 seconds without pressing the accelerator pedal.

4. Connector (Throttle Body) - Disconnect


5. Water Bypass Hose - Disconnect and Plug


6. Throttle Body - Remove

Note for installation
Tighten the throttle body mounting bolts in a cross pattern in three steps;
-1.
Tighten the bolts until they sit on the throttle body.
-2.
Tighten the bolts until the gasket is compressed and both parts are contacted.
-3.
Tighten the bolts to specified torque.

7. Throttle Body Lower Case - Remove (If needed)


8. All Removed Parts - Install
1.
Install the parts in the reverse order of removal with a new gasket and a new O-ring.