Transmission Mount Removal and Installation
4. 12 Volt Battery Base - Remove
1.
Remove the harness holder (A).
2.
Loosen the bolts (B).
3.
Remove the 12 volt battery base (C).
NOTE: When installing the 12 volt battery base, tighten the mounting bolts in the numbered sequence shown.

5. Harness Holder and Harness Clamp - Remove
1.
Remove the harness holder (A).
2.
CVT: Remove the harness clamp (B).

7. Transmission - Support
1.
Lift and support the transmission with a jack and a wood block under the transmission.

8. Transmission Mount - Remove

M/T

CVT
1.
Remove the ground cable (A).
2.
Remove the transmission mount (B).
NOTE (M/T): Do not remove the bolt (C) from the transmission mount. If the bolt is removed, the transmission mount must be replaced as an assembly.

9. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.