Intake Manifold Removal and Installation
1. Intake Manifold - Exploded View

Exploded View



NOTE: Refer to the Exploded View if needed during this procedure.

3. Intake Air Duct - Remove

4. Throttle Body - Move

NOTE:
Do not disconnect the water bypass hoses.
Do not bend the water bypass hoses excessively.

5. External Item - Remove
1.
Disconnect and remove the following intake manifold external items:
PCV hose (A)
Brake booster vacuum hose (B)
Fuel feed hose (C)
EVAP canister purge hose (D)
MAP sensor connector (E)
Intake manifold bracket (F)

6. Intake Manifold Assembly - Remove

7. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE:
Tighten the bolts/nuts in three steps; tighten the bolts/nuts until the bolts/nuts sit on the intake manifold, tighten the bolts/nuts until the gasket is compressed, tighten the bolts/nuts to specified torque.
After installation, check that all tubes, hoses, and connectors are installed correctly.