CVT Oil Seal Replacement (L15B7/L15BA/L15BY (CVT))

CVT Oil Seal Replacement

Special Tools Required

Image	Description/Tool Number
	Driver Handle, 15 x 135L 07749-0010000
	Oil Seal Driver Attachment 07GAD-PG40100
	Oil Seal Driver, 65 mm 07JAD-PL9A100

NOTE: Keep all foreign particles out of the transmission.

Left Differential Oil Seal

1.	Vehicle - Lift

2.	Engine Undercover - Remove

3.	Transmission Fluid - Drain

4.	Left Driveshaft Inboard Joint - Disconnect

5.	Left Differential Oil Seal - Remove

6.	Left Differential Oil Seal - Install

Install the left differential oil seal (A) flush with the transmission housing using the 15 x 135L driver handle and the oil seal driver attachment.

NOTE: Before installation, apply a light coat of clean transmission fluid to the surface both of the press-fit and the lip that are on the oil seal.

7.	Left Driveshaft Inboard Joint - Connect

8.	Transmission Fluid - Refill

9.	Transmission Fluid Level - Check

10.	Engine Undercover - Install

Right Differential Oil Seal

1.	Vehicle - Lift

2.	Engine Undercover - Remove

3.	Transmission Fluid - Drain

4.	Intermediate Shaft - Remove

5.	Right Differential Oil Seal - Remove

6.	Right Differential Oil Seal - Install

Install the right differential oil seal (A) flush with the torque converter housing using the 65 mm oil seal driver.

NOTE: Before installation, apply a light coat of clean transmission fluid to the surface both of the press-fit and the lip that are on the oil seal.

7.	Intermediate Shaft - Install

8.	Transmission Fluid - Refill

9.	Transmission Fluid Level - Check

10.	Engine Undercover - Install