Engine Mount Tightening Procedure (K20C1) - Honda Civic FC/FK 2016-2021

Engine Mount Tightening Procedure

NOTE: Reinstall the mounting bolts and support nuts in the sequence given in the following steps. Failure to follow this sequence may cause excessive noise, vibration, and severe damage to the engine mount brackets.

1.	Jack - Remove

2.	Engine/Transmission Mount - Tightening Procedure

NOTE: When installing the side engine mount, tighten the

bolts at first and temporarily tighten the

bolt while attaching the side engine mount bracket to the side engine mount, then tighten the remaining bolts and nuts according to the sequence shown in the following table.

Tightening Sequence

Mount Removed	Mount Tightening Sequence
Side Engine Mount	, , and
Transmission Mount	and
Torque Rod

Tightening Torque

Mount No.	Mount Name	Mount Bolt/Nut Tightening Sequence
Mount No.	Mount Name
	Side Engine Mount	49 N·m (5.0 kgf·m, 36 lbf·ft) Replace.	54 N·m (5.5 kgf·m, 40 lbf·ft) Replace.	54 N·m (5.5 kgf·m, 40 lbf·ft) Replace.	93 N·m (9.5 kgf·m, 69 lbf·ft) Replace.	93 N·m (9.5 kgf·m, 69 lbf·ft) Replace.
	Transmission Mount	74 N·m (7.5 kgf·m, 55 lbf·ft) Replace.	54 N·m (5.5 kgf·m, 40 lbf·ft) Replace.	54 N·m (5.5 kgf·m, 40 lbf·ft) Replace.
	Torque Rod	93 N·m (9.5 kgf·m, 69 lbf·ft) Replace.	93 N·m (9.5 kgf·m, 69 lbf·ft) Replace.