Engine Compression Inspection

NOTE: After this inspection, you must reset the PCM. Otherwise, the PCM will continue to stop the injectors from operating.

1. Engine - Warm Up
1.
Start the engine. Hold the engine speed at 3,000 rpm with no load in neutral until the radiator fan comes on, then let it idle.

3. ALL INJECTORS STOP - Select
1.
Select ALL INJECTORS STOP in the PGM-FI INSPECTION menu with the HDS.

5. Engine Compression - Inspect
1.
Attach a compression gauge to the spark plug hole.
2.
Step on the accelerator pedal to open the throttle fully, then crank the engine with the starter motor, and measure the compression.
Compression Pressure:
Above 930 kPa (9.48 kgf/cm2, 134.8 psi)
3.
Measure the compression on the remaining cylinders.
Maximum Variation:
Within 200 kPa (2.04 kgf/cm2, 29.0 psi)
4.
If the compression is not within specifications, perform a cylinder leak down test to determine the problem area. Then check the following items, and remeasure the compression:
5.
Remove the compression gauge from the spark plug hole.