Throttle Body Removal and Installation

Do not insert your fingers into the installed throttle body when you turn the vehicle to the ON mode, or while the vehicle is in ON mode. If you do, you will seriously injure your fingers if the throttle valve is activated.

NOTE: enu_12713377_2.0 Where icon is shown, click for further information.


1

9164_4.0_enu_15125504_5.0

enu_12713377_2.0
Detailed information, notes and precautions
enu_12714505_1.0
Torque: N·m (kgf·m, lbf·ft)
enu_12714524_1.0
Replace

4. Connector (Throttle Body) - Disconnect


5. Harness Bracket - Remove


6. Water Bypass Hose - Disconnect and Plug


7. Throttle Body and Throttle Flange Plate - Remove

NOTE: Be careful not to drop the throttle flange plates to prevent other parts from damage.

Note for installation
When tighten the throttle body mounting bolts in a cross pattern in three steps;
-1.
Tighten the bolts until they sit on the throttle body.
-2.
Tighten the bolts until the gasket is compressed and both parts are contacted.
-3.
Tighten the bolts to specified torque.

8. Throttle Body Cover - Remove (If Necessary)
Note for installation

Tighten the mounting screws to the specified torque in the numbered sequence shown.


9. Throttle Body Lower Case - Remove (If Necessary)


10. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

12. Throttle Position - Learn
1.
Do the throttle position learn procedure.
NOTE: Turn the vehicle to the OFF (LOCK) mode and the ON mode as shown.