Wheel Bolt Removal and Installation
Special Tools Required
Image Description/Tool Number
8616757.png Ball Joint Remover, 28 mm 07MAC-SL00202
Do not use a hammer or impact tools (pneumatic or electric).
Be careful not to damage the threads of the wheel bolts.

Front

5. Wheel Bolt - Remove
1.
Remove the screws (A).
2.
Separate the wheel bolt (A) from the hub (B).
NOTE: If the angle of the remover against the wheel bolt is not vertical, readjust the ball joint remover by turning the head (C) of the adjusting bolt (D).
3.
Remove the wheel bolt (A) through the clearance (B) of the splash guard (C) as shown.

Rear

5. Wheel Bolt - Remove
1.
Separate the wheel bolt (A) from the hub (B).
NOTE: If the angle of the remover against the wheel bolt is not vertical, readjust the ball joint remover by turning the head (C) of the adjusting bolt (D).
Do not use a hammer or impact tools (pneumatic or electric).
Be careful not to damage the threads of the wheel bolts.

NOTE: How to read the torque specifications.

Front

1. Wheel Bolt - Install
1.
Install the wheel bolt (A) through the clearance (B) of the splash guard (C) as shown.
2.
Insert a new wheel bolt (A) into the hub (B) while aligning the splined surfaces (C) on the hub hole with the wheel bolt.
NOTE:
Before installing the new wheel bolt, clean the mating surfaces on the bolt and the hub.
Degrease the area around the wheel bolt and the threaded section of the nut.
3.
Adjust the measurement (D) with the washers (P/N 94101-14800 or equivalent) (E).
4.
Install a nut (P/N 90304-SHJ-A91 or equivalent) (F) hand-tight.
NOTE:
Make sure the wheel bolt is installed vertically to the hub disc surface.
Do not install the nut and the washers that have been used as tools on a vehicle.
5.
Tighten the nut.
NOTE:
Do not exceed the maximum torque limit.
Make sure there is no gap (G) between the bolt and the hub.
Limited torque: 127 N·m (13.0 kgf·m, 94 lbf·ft) max.
NOTE: If you cannot tighten the wheel nut to the specified torque when installing the wheel, replace the front hub.
6.
Install the screws (A).

Rear

1. Wheel Bolt - Install
1.
Insert a new wheel bolt (A) into the hub (B) while aligning the splined surfaces (C) on the hub hole with the wheel bolt.
NOTE:
Before installing the new wheel bolt, clean the mating surfaces on the bolt and the hub.
Degrease the area around the wheel bolt and the threaded section of the nut.
2.
Adjust the measurement (D) with the washers (P/N 94101-14800 or equivalent) (E).
3.
Install a nut (P/N 90304-SHJ-A91 or equivalent) (F) hand-tight.
NOTE:
Make sure the wheel bolt is installed vertically to the hub disc surface.
Do not install the nut and the washers that have been used as tools on a vehicle.
4.
Tighten the nut.
NOTE:
Do not exceed the maximum torque limit.
Make sure there is no gap (G) between the bolt and the hub.
Limited torque: 127 N·m (13.0 kgf·m, 94 lbf·ft) max.
NOTE: If you cannot tighten the wheel nut to the specified torque when installing the wheel, replace the rear hub bearing unit as an assembly.