Clean and dry the pulley end crankshaft oil seal housing.
2.
Apply a light coat of new engine oil to the lip of the new pulley end crankshaft oil seal.
3.
Using the driver handle, 15 x 135L and the hub dis/assembly tool, 42 mm, drive in the new pulley end crankshaft oil seal (A) squarely into the cam chain case to the specified installed height.
4.
Measure the distance between the cam chain case surface (A) and the pulley end crankshaft oil seal (B).
Oil Seal Installed Height (C):
K20C1 Engine:
5.6?5.9 mm (0.220?0.232 in)
K20C2 Engine:
5.4?6.1 mm (0.213?0.240 in)
5.
Clean the excess oil off the crankshaft, and check that the pulley end crankshaft oil seal lip is not distorted.
4.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
