Cruise Control Combination Switch Removal, Installation, and Test

SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before doing repairs or service.

2. Steering Wheel Trim - Remove

Screw fixed type

Hook fixed type
1.
Remove the screws (A).
2.
Disconnect the ground cable (B) with screw.
3.
Disconnect connectors (C).
4.
Remove the steering wheel trim (D).

3. Cruise Control Combination Switch -Remove

4. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

1. Cruise Control Combination Switch - Test
1.
Measure the resistance between the cruise control combination switch 12P connector (male terminals) terminals No. 5 and No. 6 according to the table.
Position
Resistance at normal ambient temperature
OFF
2.0?2.4 k?
CRUISE
(Pressed and held)
54.3?66.3 ?
CANCEL (Pressed and held)
165.0?201.7 ?
SET?
(Pressed and held)
401.7?491.0 ?
RES?
(Pressed and held)
802.7?981.1 ?
If there is no resistance in one or more positions, replace the cruise control combination switch.
2.
Check the LED for illumination by applying power and ground to the terminals according to the table.
NOTE: Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
If the results are not as specified, replace the cruise control combination switch.