Disconnect the connector (A) by pulling the lock (B) and the lever (C) in the numbered sequence shown.
NOTE: Check the connector for corrosion, dirt, or oil, and clean or repair if necessary.
2.
Check for continuity between the connector (male terminals) terminals at the transmission range switch side. There should be continuity between the terminals in the following table for each transmission range switch position.
If the test results are OK, the transmission range switch test is finished.
If there is no continuity between any terminals, check the transmission range switch installation. If the switch installation is OK, replace the transmission range switch.
3.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
