DTC Troubleshooting: U3000-51
DTC U3000-51: SRS Unit Programming Error
NOTE:
Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part number and were properly installed.
This DTC is indicated when the SRS unit update is not completed properly.
Never press the engine start/stop switch, while updating the SRS unit. If you press the engine start/stop switch, before you complete the SRS unit update procedure, the SRS unit can be damaged. If there is a problem with the update, keep the vehicle in ON mode.
Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information.

DTC Description
DTC
U3000-51 SRS unit programming error
  

1.
Problem verification (update):

Problem verification (update)
?1.
Do the SRS unit update procedure.

?2.
Clear the DTCs with the HDS.


?3.
Turn the vehicle to the ON mode, then wait for 10 seconds.

?4.
Check for DTCs with the HDS.
DTC Description
DTC
U3000-51 SRS unit programming error
  

Is DTC U3000-51 indicated?

     
YES
     
     
     
The failure is duplicated. Replace the SRS unit.?
     
NO
     
     
     
Update is complete.?