DTC Troubleshooting: B1647
DTC B1647 : Passenger's Door LF Antenna Circuit Short
NOTE:
Front passenger's*1 is for 4-door, passenger's*2 is for 2-door.
DTC Description
DTC
B1647 Passenger's Door LF Antenna Circuit Short
DTC (Keyless Access Control Unit)
1.
Problem verification:
Problem verification
?1.
Clear the DTCs with the HDS.
Clear DTCs
?2.
Select the KEYLESS ACCESS CONTROL UNIT from the ONE-PUSH START system select menu with the HDS, and enter the SELF CHECK.
One-Push - KEYLESS ACCESS CONTROL UNIT - SELF CHECK
?4.
Check for DTCs with the HDS.
DTC Description
DTC
B1647 Passenger's Door LF Antenna Circuit Short
Is DTC B1647 indicated?
Intermittent failure, the system is OK at this time. Check for loose or poor connections.?
2.
Shorted wire check (EXT FR AS+, EXT FR AS- lines):
Shorted wire check (EXT FR AS+, EXT FR AS- lines)
?1.
Turn the vehicle to the OFF (LOCK) mode.
?2.
Disconnect the following connectors.
Body control module connector F (36P)
Front passenger's*1 /passenger's*2 door outer handle 8P connector
?3.
Check for continuity between test points 1 and 2 individually.
Test condition
Vehicle OFF (LOCK) mode Body control module connector F (36P): disconnected Front passenger's*1 /passenger's*2 door outer handle 8P connector: disconnected
Test point 1
Test point 2
Body ground
Test point 1
Test point 2
Body ground
Is there continuity?
Repair a short to ground in the wire.?
The EXT FR AS+ and EXT FR AS- wires are not shorted. Go to step 3.
3.
Shorted wire check (EXT FR AS+ to EXT FR AS- line):
Shorted wire check (EXT FR AS+ to EXT FR AS- line)
?1.
Check for continuity between test points 1 and 2.
Test condition
Vehicle OFF (LOCK) mode Body control module connector F (36P): disconnected Front passenger's*1 /passenger's*2 door outer handle 8P connector: disconnected
Test point 1
Test point 2
Is there continuity?
Repair a short in EXT FR AS+ to EXT FR AS- wire.?
The EXT FR AS+ and EXT FR AS- wires are OK. Go to step 4.
4.
EXT FR AS+, EXT FR AS- line output check:
EXT FR AS+, EXT FR AS- line output check
?1.
Reconnect the following connector.
Body control module connector F (36P)
?2.
Turn the vehicle to the ON mode.
?3.
Measure the voltage between test points 1 and 2.
Test condition
Vehicle ON mode Front passenger's*1 /passenger's*2 door outer handle 8P connector: disconnected
Test point 1
Front passenger's*1 /passenger's*2 door outer handle 8P connector No. 2
Test point 2
Front passenger's*1 /passenger's*2 door outer handle 8P connector No. 6
Is there voltage?