Rear Door Glass and Regulator Removal and Installation
2. Rear Door Plastic Cover - Remove
1.
Remove the plug caps (A).
2.
Remove the harness clip (B).

3.
Disconnect the connector (C).
4.
Remove the rear door plastic cover (D).
NOTE: If the plastic cover is damaged or torn, replace it with a new one.

3. Rear Door Glass - Remove
1.
Lower the rear door glass (A) until you can see the bolts, then remove them.
2.
Pull the glass run channel (A) away as needed.
3.
Remove the nut (A) and the bolt (B).
4.
Carefully remove the rear door glass (A) out through the window slot.
NOTE: Take care not to drop the glass inside the door.

4. Rear Door Regulator - Remove
1.
Disconnect the connector (A).
2.
Remove the nut (B) and bolts (C).
3.
Remove the regulator (D) through the hole in the door.

5. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE: Apply multipurpose grease to all sliding surfaces of the rear door regulator (A) where shown.