Front Seat Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

1.	12 Volt Battery Terminal - Disconnect

NOTE: Wait at least 3 minutes before starting work.

2.	Front Seat Belt Lower Anchor Bolt - Remove

3.	Front Seat Rear Foot Covers - Remove

4.	Front Seat Mounting Bolts - Remove

Rear side

Front side

5.	Front Seat - Remove

Driver's seat

Passenger's seat

From under the seat cushion, remove the harness clip (A).

Disconnect the connectors (B), (C) (for some models).

Remove the front seat (D).

6.	All Removed Parts - Install

Install the parts in the reverse order of removal.

NOTE:

Tighten the front seat mounting bolts (A) by hand first, then tighten them to the specified torque.

Tighten the front seat mounting bolts to the specified torque in the sequence shown. Slide the front seat all the way back and tighten 1 and 2, then slide it forward and tighten 3 and 4.