Clean and dry the pulley end crankshaft oil seal housing.
2.
Apply a light coat of new engine oil to the lip of a new pulley end crankshaft oil seal.
3.
Use the bearing driver attachment, 40 mm, to drive a new pulley end crankshaft oil seal (A) squarely into the oil pump to the specified installed height.
4.
Measure the distance between the oil pump case surface (A) and the pulley end crankshaft oil seal (B).
Pulley End Crankshaft Oil Seal Installed Height
9.3?10.0 mm (0.366?0.394 in)
5.
Clean the excess oil off the crankshaft, and check that the oil seal lip is not distorted.
4.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
