Engine Start/Stop Switch Test
1. Heater Control Panel - Remove (Without Climate Control)


2. Climate Control Unit - Remove (With Climate Control)


3. Engine Start/Stop Switch - Test
1.
Check the engine start/stop switch (A) according to the table.
NOTE:
When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).


10P type

12P type
2.
If the result is not as specified, replace the engine start/stop switch.

4. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.