DTC Troubleshooting: P1009
DTC P1009: VTC Advance Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.
If DTC P0341 is stored at the same time as DTC P1009, troubleshoot DTC P1009 first, then recheck for DTC P0341.
If DTC P1009 set after replacing the VTC actuator, verify that the correct timing marks on the crank pulley were used. .

DTC Description
Confirmed DTC
Pending DTC
Freeze Frame
P1009 VTC Advance Malfunction
     

1.
Problem verification:

Problem verification
?1.
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

?2.
Clear the DTC with the HDS.


?3.
Start the engine.

?4.
Check for Pending or Confirmed DTCs with the HDS.
DTC Description
Confirmed DTC
Pending DTC
Freeze Frame
P1009 VTC Advance Malfunction
     

Is DTC P1009 indicated?

     
YES
     
     
     
Go to step 2.
     
NO
     
     
     
Intermittent failure, the system is OK at this time.?
2.
VTC strainer visual check:

VTC strainer visual check
?1.
Turn the ignition switch to LOCK (0), or press the engine start/stop button to select the OFF mode.

?2.
Remove the VTC strainer (A), and check it for clogging.


Is the strainer OK?

     
YES
     
     
     
Go to step 3.
     
NO
     
     
     
3.
VTC oil control valve operation check:

VTC oil control valve operation check
?1.
Test the VTC oil control solenoid valve.

Is the VTC oil control solenoid valve OK?

     
YES
     
     
     
Go to step 4.
     
NO
     
     
     
4.
VTC actuator check:

VTC actuator check
?1.
Inspect the VTC actuator.

Is the actuator OK?

     
YES
     
     
     
Check the VTC system oil passages and clean them if needed, then do the repair verification.
     
NO
     
     
     
Repair verification (OBD STATUS check):

?1.
Turn the ignition switch to ON (II), or press the engine start/stop button to select the ON mode.

?2.
Reset the PCM with the HDS.


?3.
Do the CKP pattern clear procedure.

  

?4.
Do the PCM idle learn procedure.

?5.
Do the CKP pattern learn procedure.

  

?6.
Select the VTC TEST in the INSPECTION MENU with the HDS.

  

?7.
Monitor the OBD STATUS for DTC P1009 in the DTCs MENU with the HDS.
DTC Description
OBD STATUS
P1009 VTC Advance Malfunction
 


Does the HDS indicate PASSED, FAILED, or NOT COMPLETED?

     
PASSED
     
     
     
Troubleshooting is complete. If any other Pending or Confirmed DTCs were indicated, go to the indicated DTC's troubleshooting.?
     
FAILED
     
     
     
Go to step 1 and recheck.
     
NOT COMPLETED
     
     
     
Retest and check the OBD STATUS again.