|
DTC Troubleshooting: B12E4
DTC B12E4: Electric Steering Lock High Level Failure of MTRCUT2
|
DTC Description |
DTC |
|
B12E4 Electric Steering Lock High Level Failure of MTRCUT2 |
| |
|
NOTE: Before troubleshooting, make sure the No. B9 (20 A) and No. B31 (10 A) fuses in the under-dash fuse/relay box are OK.
|
1. |
Problem verification:
Problem verification
|
?1. |
Clear the DTCs with the HDS.
|
|
?2. |
Do this procedure 10 times: Press the engine start/stop button to select the OFF, ACC, ON, and OFF mode. |
|
?3. |
Check for DTCs with the HDS.
|
DTC Description |
DTC |
|
B12E4 Electric Steering Lock High Level Failure of MTRCUT2 |
| |
| | |
Is DTC B12E4 indicated?
|
|
|
|
|
|
|
Intermittent failure, the system is OK at this time. Check for loose or poor connections.? |
|
2. |
Open wire check (GND line):
Open wire check (GND line)
|
?1. |
Disconnect the following connector.
|
|
?2. |
Check for continuity between test points 1 and 2.
|
Test condition |
OFF mode
Electric steering lock 12P connector: disconnected |
|
Test circuit |
GND |
|
Test point 1 |
Electric steering lock 12P connector No. 7 (BLK) |
|
Test point 2 |
Body ground | |
|
| |
Is there continuity?
|
|
|
The GND wire is OK. Go to step 3. |
|
|
|
Repair an open or high resistance in the ground wire or poor ground (G501).? |
|
3. |
Open wire check (MTR CUT 2 (IG1) line):
Open wire check (MTR CUT 2 (IG1) line)
|
?1. |
Disconnect the following connector.
|
|
?2. |
Check for continuity between test points 1 and 2.
|
Test condition |
OFF mode
Electric steering lock 12P connector: disconnected
Keyless access control unit connector C (24P): disconnected |
|
Test circuit |
MTR CUT 2 (IG1) |
|
Test point 1 |
Electric steering lock 12P connector No. 4 (GRN) |
|
Test point 2 |
Keyless access control unit connector C (24P) No. 16 (GRN) | |
|
| |
Is there continuity?
|
|
|
|
|
|
|
Repair an open or high resistance in the wire.? | |