DTC Troubleshooting: B1648
DTC B1648: Passenger Door LF Antenna Circuit Open
DTC Description
DTC
B1648 Passenger's Door LF Antenna Circuit Open
 

1.
Problem verification:

Problem verification
?1.
Clear the DTCs with the HDS.


?2.
Select the MODE MENU from the HDS, then enter the SELF CHECK.

  

?3.
Do the SELF CHECK.

?4.
Check for DTCs with the HDS.
DTC Description
DTC
B1648 Passenger's Door LF Antenna Circuit Open
 

Is DTC B1648 indicated?

     
YES
     
     
     
Go to step 2.
     
NO
     
     
     
Intermittent failure, the system is OK at this time. Check for loose or poor connections.?
2.
Keyless access control unit EXT FR AS+, EXT FR AS- line output check:

Keyless access control unit EXT FR AS+, EXT FR AS- line output check
?1.
Press the engine start/stop button to select the OFF mode.

?2.
Disconnect the following connector.

?3.
Press the engine start/stop button to select the ON mode.

?4.
Select KEYLESS ACCESS CONTROL from the ONE-PUSH START system select menu with the HDS, and enter FUNCTIONAL TESTS.

  

?5.
Connect the voltmeter to test points 1 and 2.
Test point 1
Front passenger's door outer handle 8P connector No. 2 (GRN)
Test point 2
Front passenger's door outer handle 8P connector No. 6 (BLU)


?6.
Select FRONT PASSENGER DOOR ANTENNA with the HDS.

Is there voltage?

     
YES
     
     
     
Faulty front passenger's door LF antenna; replace the front passenger's door outer handle.?
     
NO
     
     
     
Go to step 3.
3.
Open wire check (EXT FR AS+, EXT FR AS- lines):

Open wire check (EXT FR AS+, EXT FR AS- lines)
?1.
Press the engine start/stop button to select the OFF mode.

?2.
Disconnect the following connector.

?3.
Check for continuity between test points 1 and 2 respectively.
Test condition
OFF mode
Keyless access control unit connector A (32P): disconnected
Front passenger's door outer handle 8P connector: disconnected
Test circuit
EXT FR AS+
Test point 1
Keyless access control unit connector A (32P) No. 22 (GRN)
Test point 2
Front passenger's door outer handle 8P connector No. 2 (GRN)

Test circuit
EXT FR AS-
Test point 1
Keyless access control unit connector A (32P) No. 6 (BLU)
Test point 2
Front passenger's door outer handle 8P connector No. 6 (BLU)


Is there continuity?

     
YES
     
     
     
     
NO
     
     
     
Repair an open or high resistance in the wire.?