Cruise Control Symptom Troubleshooting Index
Symptom
Diagnostic procedure
Also check for
Cruise control cannot be set
1.
Check the PGM-FI system.
2.
Check the No. B21(10 A) fuse in the under-dash fuse/relay box.
3.
Do the cruise control combination switch test.
4.
Do the cruise control input test.
Open circuit, loose or disconnected terminals: GRN, TAN, GRY, or LT GRN wire between the cruise control combination switch and the gauge control module
Faulty gauge control module
Faulty cable reel
Cruise control can be set, but the cruise main indicator does not come on
Faulty gauge control module
Cruise control can be set, but the cruise control indicator does not come on
Faulty gauge control module
Vehicle does not accelerate accordingly when the RES+ button is pressed
  
Set speed does not cancel when the brake pedal is pressed
1.
Do the brake pedal position switch test.
2.
Do the cruise control input test.
Test the brake pedal position switch signal input.
3.
Check the PGM-FI system.
Faulty brake pedal position switch
An open in the wire between the PCM and the brake pedal position switch
A wire shorted to ground or power between the PCM and the brake pedal position switch
Set speed does not cancel (engine rpm stays high) when the clutch pedal is pressed for more than five seconds (M/T)
Faulty clutch pedal position switch A
An open in the wire between the PCM and clutch pedal position switch A
A wire shorted to ground or power between the PCM and clutch pedal position switch A
Faulty clutch pedal stroke sensor
Set speed does not cancel when the CRUISE button is pressed
  
Set speed does not cancel when the CANCEL button is pressed
  
Set speed does not resume when the RES+ button is pressed (with the CRUISE button pressed on, and set speed temporarily canceled by pressing the brake pedal)